Install ES3C28P

Flash XiaoZhi on the LCDWiki 2.8-inch ESP32-S3 from Chrome or Edge over USB.

Chip - · 0 variants

Firmware -
Target -
Web Serial is not available here. Open this page in Chrome or Edge on a desktop computer.

Loading board list…

  1. 1
    Plug the ES3C28P into USB. Use the native USB-C port, not a UART dongle, for the first flash.
  2. 2
    Hold BOOT if the serial port does not appear, then click Connect and install and pick the device.
  3. 3
    Allow erase on first install so the 16 MB partition table (including the theme slot) is written. Press RESET when it finishes.

Install a file from this computer

Use a full merged-binary.bin, or a theme package for the ES3C28P theme partition.

No file selected